If
your vehicle has this
feature, the control is
located on the outboard
sides of the front
seats. With the ignition on,
briefly press the top of
the control where it
is marked AUTO to
activate the massaging
lumbar feature.
The massage cycle will run continuously for up to
10
minutes and can be interrupted
by
briefly pressing
the bottom of the control. The lumbar support can
be adjusted during the massage cycle by moving the
control forward to increase support and rearward
to decrease support. The massage cycle will continue to
T~T!
pypn
if
the
ignIt[cn
is
t~~rnprj
to
OFF
Irnless
interrupted.
If
your vehicle has this
feature, the control is
located on the outboard
side of each front seat. It is
marked AUTO.
With the ignition
in
ON,
first use the power seat csntro!
to get the proper position. Then press the top
of
the
control where it is marked AUTO. The system will inflate
the cushion and take a reading, then automatically
deflate the cushion to a suggested level of comfort by
distributing the pressure evenly. The seatback and
cushion will inflate to adjust to the driver’s body position
II I
LVVW
LW
lwul-I
I
Ill
IULG
byblca.
:.-
L
I-
x-....
-:-.,+-
-.,-I,,
If
your vehicle has this feature, it will not have the
adaptive seat feature.
1-3