Dual Climate Control System
With this system you can control the heating, cooling
and ventilation for your vehicle.
3.
Automatic Operation
AUTO (Automatic):
When this button is pressed and
the temperature is set, the system will automatically
control the inside temperature, the air delivery mode and
iile
iarl
sped
nu
I
u
wiii
appear
ur1
ii~e
ciispiay.
I
.-.--
I.
Press the AUTO button.
2.
Adjust the temperature to a comfortable setting
between 70°F (21°C) and 80°F (27°C).
Choosing
the coldest or warmest temperature
setting will not cause the system to heat or cool
any faster.
If
you set the system at the warmest
temperature setting, the system will remain
in
manual mode at that temperature and it will not go
into automatic mode.
In cold weather, the system will start at reduced fan
speeds to avoid blowing cold air into your vehicle
until warmer air is available. The system will
start out blowing air at the floor but may change
modes automatically as the vehicle warms up
to maintain the chosen temperature setting. The
length
of
time needed for warm up will depend on
the outside temperature and the length of time
that has elapsed since your vehicle was last driven.
Wait for the system to regulate. This may take from
10
to
30
minutes. Then adjust the temperature,
if
necessary.
Do not cover the solar sensor located in the center
of
the instrument panel, near the windshield. For more
information on the solar sensor, see
Sensors
later in
this section.
When your vehicle is first started, the display will show
the driver’s temperature setting, the fan speed, the
air delivery mode and the outside temperature.
When the ENG/MET (English/metric) button on the
Driver Information Center (DIC)
is
pressed, the display
will
show readings
in
Fahrenheit or Celsius. Use the
ENG/MET button to toggle between them.
3-29
To Next Page
Loading...
Need help?
General
