Checking the Fluid Level
Prepare you vehicle as follows:
Park your vehicle on a level place. Keep the engine
running.
With the parking brake applied, place the shift lever
in PARK (P).
With your foot on the brake pedal, move the shift
lever through each gear range, pausing for about
three seconds in each range. Then, position the shift
lever in PARK (P).
Let the engine run at idle for three
to
five minutes.
Then, without shutting
off
the engine, follow these steps:
The transaxle fluid cap is
located next to the radiator
hose and below the
engine air cleanedfilter
assembly on the driver’s
side of the vehicle.
See
Engine
Compartment
Overview on page
5-12
for more information
on location.
1.
After removing the engine air cleaner/filter assembly
to
reach the transaxle fluid cap, turn the cap
counterclockwise to remove. Pull out the dipstick
and wipe it with a clean rag or paper towel.
2.
Push it back in all the way, wait three seconds, and
then pull it back out again.
3.
Check both sides of the dipstick, and read the lower
level. The fluid level must be in the
cross-hatched area.
4.
If
the fluid level is in the acceptable range, push the
dipstick back in all the way and turn the handle
clockwise. Reinstall the engine air cleanedfilter
assembly.
5-22
To Next Page
Loading...
Need help?
General
