Memory Seat, Mirrors and Steering
Wheel
Your vehicle may be
equipped with the memory
package. The controls
for these features
are located on the driver’s
door panel, and are
used to program and recall
memory settings for the
driver’s seating positions.
Use the following steps to program each button:
1.
Adjust the driver’s seat (including the seatback
recliner. lumbar and head restraint, both outside
mirrors and the steering wheel to a comfortable
position.
2. Press the SET button.
3.
Within five seconds, press button
1.
After a brief
delay,
a
single beep
will
swnd
threugh
the driver’s
side front speaker to let you know that the
position has been stored.
.
A
secnnd
-
-
-
-
. . _.
.
mirror,
.
. .
.
.
seating
and
steering wheel
position
can be programmed by repeating the above steps and
pressing button
2
(for driver
2).
Each time a memory
button is pressed,
a
single beep will sound. Each time
button
1
or
2
is
pressed and released while the
vehicle
is
in PARK (P), the memory positions will be
recalled after a brief delay. If the vehicle is not in
PARK (P), the memory buttons must be pressed and
held to recall the stored positions.
If
you use the remote keyless entry transmitter to enter
your vehicle, automatic seat and mirror movement
will occur. The numbers
on
the back of the transmitters,
1
and 2, correspond to the numbers on the buttons
on the door panel.
When the key is placed in the ignition in
OFF
and you
have entered the vehicle without using the remote
keyless entry transmitter, the seat and mirrors
will automatically adjust to the programmed position of
the last driver.
To
stop recall movement of the memory feature at any
time: press one of the power
seat
controls
or
memory
buttons.
2-55
To Next Page
Loading...
Need help?
General
