CIimate
Controls
and
Radio
System
Personalization
These features allow both drivers to personalize their
own climate control settings as well as their radio
settings. For more information, see
Climate Controls
Personalization on page
3-39
and
Radio Personalization
with Home and Away Feature on page
3-
102.
DIC
Vehicle
Personalization
Your vehicle is equipped with personalization capabilities
that allows you to program certain features to a
preferred setting for up to two people. The number of
programmable features varies depending upon
which model of the vehicle
is
purchased. On all vehicles,
features such as climate control settings, radio preset
settings, exterior lighting at unlock, remote lock and
unlock confirmation, and automatic door locks
have already been programmed for your convenience.
Some vehicles are equipped with additional features that
can
be
programmes
inciuaing
ine
seai
posiiion,
steering column position
(if
equipped) and outside mirror
position. The navigation screen preferences
(if
equipped) will remain at the last set position.
!f
ymur
vehicle
is
equipped with the ability to program
additional personalization features, the driver’s
preferences are recalied by pressing the unlock button
on the remote keyless entry transmitter or by pressing
the appropriate memory button,
1
or
2,
located on
the driver’s door. Certain features can be programmed
not to recall until the key is placed
in
the ignition.
To change feature preferences you must use one of the
following procedures.
Entering Feature Programming
To enter feature programming mode, do the following:
1.
Turn the ignition to ON, making sure the vehicle is in
PARK (P).
2.
If your vehicle has memory settings, press the
appropriate memory button,
1
or
2,
located on
the driver’s door panel. The DIC display will show
either
1
or
2
depending on which button was
selected. Make sure the number on the DIC display
matches the number on the back of your key fob.
PROGRAMMING appears on the DIC display.
2.
Przss
:!x
!!K?
bzttc::
LX:til
FEATL’ZE
4. Press the ON/OFF button to enter FEATURE
PROGRAMMING.
3-67