The following procedure allows the ignition to
be
turned
to OFF and for ignition key removal in case of a
dead battery or low voltage battery
for
vehicies equipped
with a column shift lever.
1.
Verify that the shift lever is in PARK (P).
2.
Locate the override
access slot underneath
the steering column
below the lock cylinder.
3.
Remove the override access slot cap.
4.
Insert a tool into the access slot, press in and hold.
3.
I
urrl
ii~e
iyrliiiorl
key
io
urr.
6.
Remove the tool from the slot.
7.
Remove the key from the ignition.
8.
Reinstall the override access slot cap.
--
h
-7
The following procedure applies only
to
vehicles
equipped with the console shift lever and is used to shift
the transaxie out of PARK
(PI
in
case of a dead
battery or low voltage battery.
The console shift lock
release is located on the
front of the center console.
To
access the shift lock release, do the following:
1.
Verify that the shift lever is in PARK
(P).
2.
Pull up the rubber mat located on the front of the
center console.
3.
Remove the shift lock release hole cover by prying
it open with a small diameter tool.
2-3
1