Using HomeLink@
Press and hold the appropriate HomeLink@ button for at
least half
of a second. The indicator light will come
on while the signal is being transmitted.
Erasing HomeLink@ Buttons
To erase programming from the three buttons do the
following:
1.
Press and hold down the two outside buttons until
2.
Release both buttons. Do not hold for longer than
HomeLink@ is now in the train (learning) mode and can
be programmed at any time beginning with Step
2
under “Programming HomeLink@.”
Individual buttons can not be erased, but they can be
reprogrammed. See “Reprogramming a Single
HomeLink@ Button” next.
the indicator light begins
to
flash, after 20 seconds.
30 seconds.
Reprogramming a Single HomeLink@
Button
To
program a device to HomeLink@ using a HomeLink@
button previously trained, follow these steps:
1.
Press and hold the desired HomeLink@ button.
Do
not release the button.
2.
The indicator light will begin to flash after
20
seconds. While still holding the HomeLink@
button, proceed with Step
2
under “Programming
HomeLink@.”
Resetting Defaults
To
reset HomeLink@ to default settings do the following:
1.
Hold down the two outside buttons for about
20
seconds until the indicator light begins to flash.
2.
Continue
to
hold both buttons until the HomeLink@
indicator light turns
off.
3. Release both buttons.
For questions or comments, contact HomeLink@ at
1-800-355-3515, or on the internet at
www.homelink.com.
2-50
To Next Page
Loading...
