The RainsenseTM system can be activated by turning
the wiper band to one of the five sensitivity levels
indicated on the wiper stalk. The position closest to
OFF
is the lowest sensitivity setting, level one. This allows
more rain or snow to collect on the windshield between
wipes. Turning the wiper band away from you to
higher sensitivity levels increases the sensitivity of the
system and frequency of wipes. The highest sensitivity
setting, level five is closest to
LO.
A single wipe will
occur each time you turn the wiper stalk to a higher
sensitivity level to indicate that the sensitivity level has
been increased.
Notice:
The wipers must be turned
off
when going
through a car wash to avoid damage.
The MIST and wash cycles operate as normal and are
not affected by the RainsenseTM function. The
RainsenseTM system can be overridden at any time by
manually turning the wiper band to
LO
or HI speed.
When RainsenseTM is active, the headlamps will turn on
automatically. The headlamps will turn
off again once
is dark, they will remain on. See
Wiper-Activated
Headlamps
under
Exterior Lamps
on
page
3-15
for more
information.
Notice:
Do not place stickers or other items on the
exterior glass surface directly in front of the
moisture sensor. Doing this could cause the
moisture sensor
to malfunction.
the
Y!@?rs
tn!??
cff
if
it
is
!i$t
PnnL!gh
cutside.
!f
it
Winds'-
'eld
Washer
in
freezing weather, don't use your washer
until the windshield
is
warmed. Otherwise the
washer fluid can form ice
on
the windshield,
blocking your vision.
At the top of the turn signal/multifunction lever there is a
paddle with the word PUSH on it. To spray washer
fluid on the windshield, press and release this paddle.
The wipers will clear the windshield and either stop
or return to your preset speed. For more washer cycles,
press and hold the paddle.
CHECK WASHER FLUID will be displayed on the Driver
Information Center (DIC) when the washer fluid
reaches a low level.
3-1
1
To Next Page
Loading...
Need help?
General
