Tire Pressure Display
This feature will allow the individual tire pressure
readings to be displayed when using the INFO button to
scroll through the DIC displays. Even with this feature
programmed to be turned
off, a low or high tire pressure
condition will still cause the CHECK TIRE PRESSURE
message to be displayed on the DIC. See
DIC
Warnings
and Messages on page
3-60
for more information.
Programmable Modes
Mode
1:
ON
Mode
2:
OFF
Before your vehicle was shipped from the factory, it was
programmed to Mode
1.
The mode to which the
vehicle was programmed may have been changed since
it left the factory. To determine the mode to which the
vehicle is programmed or to program the vehicle to
a different mode, do the following:
1.
Enter FEATURE PROGRAMMING following the
2.
Press the down arrow on the INFO button until
instructions listed previously.
TIRE PRESSURE DISPLAY appears on the DIC
display.
3.
To turn
on
the feature, press the ON/OFF button
until ON appears on the DIC display. To turn it
off,
press the ON/OFF button until OFF appears on
the display.
The mode you selected is now set. You can either exit
the programming mode by following the instructions
later in this section or program the next feature available
on your vehicle.
Driver’s Name SeVRecall
If your vehicle has the optional memory package, you
will have this feature. This feature allows individual
driver’s names to be displayed in the DIC when
the ignition is turned to ON. This feature only works
when the remote keyless entry transmitter is used
to unlock the vehicle or when buttons
1
or
2
on the
driver’s door are pressed. See your dealer for assistance
in programming this feature.
Exiting Feature Programming
To
exit FEATURE PROGRAMMING, press the INFO
RESET or INFO button.
3-78
To Next Page
Loading...
Need help?
General
