Cadillac 2003 DeVille User Manual

1. Find the aim dot on the lens of the low beam lamps.
2. Measure the distance from the ground to the aim
dot on each lamp;
if left low beam, subtract two
inches. Record this distance.
3. At the wall or other flat surface, measure from the
and draw or tape a horizontal line the width of
the vehicle.
nr-1 lnrJ ~~n\~rorrl
thn
vnc-nr,JnA
A:-+----
S---
I?&-- 0
y#wusau U~YIU~U
LIIU IUVWIU~U
u13LUlIlrG
IIUIII JLGp L
4. Turn on the low-beam headlamps and place a
piece of cardboard or equivalent in front of the
headlamp not being aimed. This should allow only
the beam of light from the headlamp being
aimed to be seen on the flat surface.
FC?!!E?.- !?e !?c? CC!'.'~T 2 !md!mp tZ iGlprsK2 bea;;;
cut-off when aiming. Covering a headlamp may
cause excessive heat build-up which may cause
damage to the headlamp.
5-5 1

Cadillac 2003 DeVille Specifications

General

Brand	Cadillac
Model	2003 DeVille
Category	Automobile
Language	English