8.5
INCHES
(21
cm)
-.I
l-
3.5
INCHES
(8.5
cm)
2.
Find the jacking location from the diagrams above
and corresponding hoisting notches located in the
plastic molding. The front location is
8.5
inches
(21
cm) from the rear edge of the front wheel well,
and the rear location is
3.5
inches (8.5 cm) from
the front edge of the rear wheel well.
The notches may also be labeled
“JACK’
with an
arrow pointing to the jacking location on the vehicle.
5-76
To Next Page
Loading...
