To
reinstall the rear seat cushion, do the following:
A
s;_.-ty L-.t
th
isn
-
>rope route- _hrough
the seat cushion or
is
twisted won’t provide the
protection needed in a crash. If the safety belt
I
CAUT:o:::
(Continued;
I
hasn’t been rourea rnrougn rne sear
cusnlc
~ ~ at
all,
it
won’t be there to work for the next
i
passenger. The person sitting
in
that position
i
could be badly injured. After reinstalling the
seat cushion, always check to be sure that the
safety belts are properly routed and are not
twisted.
1.
Buckle the center passenger position safety belt,
then route the safety belts through the proper slots
in
the seat cushion. Don’t let the safety belts get
twisted.
2.
Slide the rear of the cushion up and under the
seatback
so the rear-locating guides hook into
the wire loops on the back frame.
3.
With the seat cushion lowered, push rearward and
then press down on the seat cushion until the
spring
locks
on both ends engage.
4.
Check to make sure the safety belts are properly
routed and that no portion of any safety belt is
trapped under the seat.
Also
make sure the seat
cushion is secured.
I
I
5-97
To Next Page
Loading...
Need help?
General
