8VHU·V *XLGH ³
Skip Measurement Mode
The “Skip Measurement” mode of the Dimension
Maser Plus allows you to take accurate measure-
ments in a cluttered room, without having to switch
measuring modes. When the Dimension Master
Plus takes a reading from an object in the way of
your target, you can set the unit to ignore this
measurement in future readings by pressing [Con-
vert] then [5]. This ignored value will remain in
memory until [On] is pressed twice, or the unit is
powered down.
Greater Math Accuracy
Equipped with a new, more powerful Integrated
Circuit Chip, the Dimension Master Plus performs
math calculations faster and with more accuracy.
Greater Fractional Accuracy
With the addition of three new fraction denomina-
tor settings, greater fractional accuracy can be
achieved. Use the following methods to display the
fraction denominator setting:
Method 1
Press [Rcl] [/] to display the current fraction de-
nominator setting. Press [+] or [
−
] to scroll through
the settings (1/2”, 1/4”, 1/8”, 1/16”, 1/32”, 1/64”).
Once the desired setting is displayed, press any key,
other than [+] or [–], to “set” your setting selection.
To Next Page
Loading...
