16 — Ma c h i n i s t ca l c ™/ Ma c h i n i s t ca l c ™ Pr o
ENTErINg DImENSIONS
Note: Unlike other Calculated Industries/Construction Master
calculators, the Machinist Calc and Machinist Calc Pro do not have a
dedicated Feet key. Feet is a secondary function located above the
7
key, so you have to use the
g
key, then
7
to enter or calculate
dimensions using Feet. Below are some examples.
Enter 2 Feet, then label as square and cubic units:
DIMENSIONS KEYSTROKE DISPLAY
2 Feet
2g7
2 FEET
2 square Feet
g7
2 SQ FEET
2 cubic Feet
g7
2 CU FEET
Enter 2 Feet, 3 Inches:
KEYSTROKE DISPLAY
2g73i
2 FEET 3 INCH
Linear Dimensions
Examples of how linear dimensions are entered (press
O
after each entry):
DIMENSIONS KEYSTROKE
23 mils
23B
4.5 Inches
4.5i
95 millimeters
95m
1,320 Feet
1320g7
201 meters
201g9
To Next Page
Loading...
