CALIENT S320 Getting Started Guide

S320 OCS Getting Started Guide
Doc. Part No. 460166-00
June 29, 2015
Rev. D10
20 of 42
CONTINENT=2
COUNTRY=48
TIME_ZONE=30
#End of configuration file
[15:16:35 root@TestNetwork:~]$gxc-config-network --autoconf
/etc/gxcnetwork.conf
--------------------------Existing Configuration---------------------------
-------------------------- CONFIGURATION SUMMARY --------------------------
Hostname: TestNetwork
IP Interfaces: Device IP Address Network Mask Default Gateway
bond0 192.168.102.192 255.255.255.0 192.168.102.1
ethA Active Interface
ethA Primary Interface
DNS Servers: 8.8.8.8
Search Domains: calient.local
NTP Servers: 192.168.120.13
Time Zone: America/Los_Angeles
---------------------------------------------------------------------------
Bonding, also called Link Aggregation, allows multiple Ethernet interfaces
to be combined into a single logical link. Various modes are available, all
of which provide redundancy; some modes also allow load balancing.
Ethernet Bonding (Type yes to Enable no to Disable) [yes] : yes
-------------------------- Configuring Hostname ---------------------------
Enter system hostname : TestNetwork
-------------------- Configuring IP Interface 'bond0' ---------------------
IP Address : 192.168.102.192
Network Subnet Mask : 255.255.255.0
Default Gateway Address : 192.168.102.1
Primary Interface : ethA

CALIENT S320 Specifications

General

Brand	CALIENT
Model	S320
Category	Switch
Language	English