CALIENT S320 - System Management

S320 OCS Getting Started Guide
Doc. Part No. 460166-00
June 29, 2015
Rev. D10
28 of 42
Shutting down interface eth0: [ OK ]
Stopping Switch-ctrl: [ OK ]
Shutting down loopback interface: [ OK ]
Bringing up loopback interface: [ OK ]
Bringing up interface bond0: [ OK ]
Bringing up interface eth1: [ OK ]
Starting Switch-ctrl: [ OK ]
Shutting down ntpd: [ OK ]
Synchronizing with time server: [ OK ]
Syncing hardware clock to system time [ OK ]
Starting ntpd: [ OK ]
[17:39:27 root@sw-714-test:~]$
3.4.3 Configuring Non-Bonding Manually
The following example shows how to manually configure non-bonding on the switch:
gxc-config-network
---------------------------------------------------------------------------
------------------- GXCP Network Configuration Utility --------------------
---------------------------------------------------------------------------
Running in interactive mode. Type 'help' for commands.
gxc-config-network> help
Available commands & options:
help
hist clear/show(*)
quit
reread
save
setup all(*)/dns/eth0/eth2/hostname/ntp/timezone
show all(*)/dns/eth0/eth2/hostname/ntp/timezone