S320 OCS Getting Started Guide
6 of 42
2 UNPACKING THE S320 OCS
2.1 Tools and Equipment Used for Unpacking
The following tools are recommended for opening the S320 OCS shipping containers:
Utility knife
#1 and #2 Phillips screwdrivers
2.2 Unpacking the S320 OCS
When unpacking the S320 OCS, remove and keep the shipping lockdown baseplate
(Figure 1), materials and containers for future shipment. The switch should only be
shipped using the original lockdown baseplate and container; otherwise, its warranty
will be void.
The S320 OCS is sensitive to electrostatic discharge (ESD). Be sure to wear either a
wrist or ankle ESD grounding strap when handling switch components.
The proper method for unpacking the S320 OCS includes the following steps:
1. Carefully inspect the exterior of each shipping container for any obvious signs of
damage that may have occurred during shipping.
2. Cut the band straps wrapped around the container.
To Next Page
Loading...
