EasyManua.ls Logo

Calorex Pro-Pac 45 - 3. PLUMBING

Calorex Pro-Pac 45
156 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The Calorex pool heat pump must be connected aer e filter in e
return pipe to e pool. If an existing heater is being retained, en e
Calorex should be connected between e filter and e oer heater.
(See Figures 3 & 4).
1. Calorex heat pumps have water inlet/outlet connections as follows:
2. Suitable breakable couplings should be installed local to heat pump.
3. If heat pump installed at lower level an pool water en isolation valves
should be fitted.
4. Drain valve or plug should be fitted to lower pipe to facilitate drain down
in winter period.
5. The condensation from e evaporator fins drains away rough holes in
e base of e unit. If desired, an optional factory fitted driptray wi 1½"
sink fitting can be fitted to allow e condensate to drain via 1½" domestic
waste piping. In is case it is necessary to ensure at e Calorex Heat
Pump is placed on a level plin so at e condensate can run away
wi adequate fall to waste ie ½" per foot minimum. A U trap should also
be incorporated into e pipework.
6. When e pipework installation is complete e pool pump should
be switched on and e system tested for leaks. Also check e filter
gauge to see at ere is not an excessive increase in back pressure. If
everying is en working normally e water circulating system is ready
to use.
7. Water circuit to and from unit to be capable of maintaining wiin specified
limits e rate of flow required by heat pump (see data sheet).
8. All pipework must be adequately supported wi allowance for
expansion/contraction especially wi plastic pipework.
9. It is recommended at when installing water system e last connections
to be made in e system should be e breakable couplings to avoid any
stresses on to e unit connections.
CORRECT DRAINAGE
FOR CONDENSATE
ELBOW
'U' TRAP
SUPPLIED BY
CONTRACTOR
ADEQUATE FALL
MODEL
Water in/out
connection size
MODEL
Water in/out
connection size
- - Pro-Pac PPT30M/MY 2" UNION SOCKET
Pro-Pac 45 1½ BSPM Pro-Pac PPT45M/MY 2" UNION SOCKET
Pro-Pac 70 1½ BSPM Pro-Pac PPT70M/MY 3" BSPM
Pro-Pac 90 1½ BSPM Pro-Pac PPT90M/MY 3" BSPM
Pro-Pac 140 2" BSPM Pro-Pac PPT140M/MY 4" BSPM
3. PLUMBING
8
SD566252 ISSUE 51
PR0-PAC SYSTEM OWNER INSTALLATION MANUAL

Table of Contents

Other manuals for Calorex Pro-Pac 45

Related product manuals