27
15
+
Water Care
The Water Care page will help you set up your ideal
filtration and heating settings� Choose between
Away from Home, Standard, Energy Savings,
Super Energy and Weekender, depending on your need�
Touch the Water Care name to choose your setting�
A green checkmark will appear on the selected icon to
confirm your choice�
When you select another water care setting, a confirmation
window appears to prevent inadvertent selection that
could result in a setup modification for your spa�
In Economy mode, the set point will be reduced by 20°F*,
which means that the heating system will not be engaged
unless the temperature falls to 20°F below the spa's set
temperature�
The filtration schedule shown on the in�k1000+ screen
will apply to the main filtration pump, most likely pump 1�
If your spa uses a circulation pump configured to run
24 hours, the screen will show you the purge setting
instead of filtration�The purges are pre-programmed for
a fixed number of minutes, therefore the duration will
be set to N/A on the screen and only the start time can
be modified�
* Default pack value
Water care modes
Away from home:
In this mode the spa will always be in economy mode;
the set point will be reduced by 20° F�
Standard:
The spa will never be in economy mode and will be
filtering according to the pack's low level configuration�
Energy Savings:
The spa will be in economy mode during the peak hours
of the day and resume normal mode on the weekend�
Super Energy Savings:
The spa will always be in economy mode during peak
hours, every day of the week�
Weekender:
The spa will be in economy mode from Monday to Friday,
and will run normally on the weekend�
The selection of dierent energy modes
you can set specic ltration cycles for each
energy mode.
Selecting a mode that matches your
usage can help keep electrical costs low.
For most owners, we would
recommend weekender mode as this will tell
the heater to be active only on
weekends, and to maintain within your
selected temperature range during the
week.
To Next Page
Loading...
