Calspas SWIM - Cleaning and Maintenance

74
66
72
Cleaning and MaintenanceCleaning and Maintenance
Removing and Reseating PillowsRemoving and Reseating Pillows
Jet Removal and ReplacementJet Removal and Replacement
Cleaning the Hydrostreamers
Cleaning the Hydrostreamers
57
75
Cleaning and Maintenance Cleaning and Maintenance
You can remove the pillows for clean-
ing and maintenance quickly and
easily. This method works for all pillow
types.
Grab the lower edge of the pillow with
both hands and rmly pull up, as you
do this the pillows inserts will pop out
of the holes.
Re-seat the pillows by aligning the pil-
low inserts with the holes and striking
the pillow hard enough for the insert
pegs to pop back in place.
Jets can be easily removed for cleaning.
Grasp the outer lip/rip of the jet and
turn it counter-clockwise until it
completely stops, you may feel the jet
loosen and pop out a bit, pull the jet
outward. The jet will be very snug and
may require additional turning force to
pop-out. DO NOT PRY OUT JETS
To replace the jet, place it in the tting
and turn clockwise until it click into
place and can be rotated freely to open
and close water ow again.
Note: have the jets turned o when removing jet inserts, it will
be easier to remove when there is no water ow through it.
Removing and Re-seating Pillows
Jet Removal and Replacement