Calspas SWIM - Page 32

32
23
+
Keypad functions
Electrical Configuration
Please do not make any changes in this section unless
you are a qualified electrician.
In this section, you can change the low-level configuration,
modify the number of phases, change the input current
value as well as change the Heat Pump current� Once the
modification is done, hold the Apply button for five seconds�
Please note that if there are two spa packs in the system
(i�e� a SwimSpa installation), the master's unit’s chosen unit
configuration must support a slave unit� If after rebooting
the chosen configuration does not support SwimSpa
installations, the in�k1000+ will return (after approximately
45 seconds) to this configuration menu and prompt the
user to select a configuration number again�
* Depending on the pack configuration, a code may be
required to modify these settings� This code is 5555�
Keypad Color (optional)
If this option is available (depending on the spa
configuration), the keypad rim color can be changed�
8 pre-defined colors are available� If the in�mix is installed,
the keypad rim color can also be associated to an in�mix
zone�
! Electrical Conguration for Certied Spa Technicians Only !
All Cal Spa units are pre-congured during
manufacturing.
If you are a technician installing a new spa pack, please
contact technical support.
1-800-629-3890 (ext 777)