76
Spa Cover and Locking System Installation Spa Cover and Locking System Installation
The spa cover can be considered one of the most important parts of your spa. The spa cover helps retain
the heat inside of your spa in all dierent types of weather. The cover works as a lid on a thermos, when
the spa is not in use the cover helps lower the amount of time the spas heater has to run for. Using the
cover will help lower your operating cost of your spa when the spa is not in use.
Note: The cover is constructed of rigid foam and metal, but it is not meant to support weight for your safe-
ty, do not sit, stand, or lie on the cover, nor should you place objects on top of the spa cover
• Covered spas will protect your spas nish from the suns ultraviolet rays.
• You are required to use the spa cover to maintain warranty coverage.
• Covering your spa prevents children or pets from drowning in your spa.
Step 1
Place cover on spa. Make sure it
is correctly positioned, with the
skirt of the cover wrapping over
your spa shell. This helps prevent
blistering and cracking from sun
exposure.
Step 2
Position the tie-down hardware
(attached to the straps of your
cover) on the side of the spa so
they are easily reached by the
cover tie-down straps.
Step 3
With the straps pulled tight (but not overly right), lightly pre-drill the location for screw place-
ment. Gently drill 3 holes - one for each screw slot in the lock.
Note: Use a low torque drill, or use the lowest setting on your drill, do not drill in the screw all
the way as the corners are designed with an air pocket inside to retain heat inside of your spa.
Too much force lay deform the shape of the corner and would not look as appealing.
Note: Illustrated corners may appear dierently to the ones
on your spa.
To Next Page
Loading...
