Technical Bulletin AN00029
11 © Novanta Corporation. All rights reserved.
8. Change the IP address to the new address you want the controller to have.
Note: When you enter an IP Address into the ‘IP Address’ field, the Device
Configuration Editor will generate an IP Gateway address for you in the ‘IP Gateway’
field. We recommend you use this generated ‘IP Gateway’ address.
9. Make the ‘Subnet Mask' the same as you are using in the local network adapter.
10. If your ‘IP Gateway’ address needs to be differnet from the address generated for
you in step 8, enter a valid ‘IP Gateway’ address into the ‘IP Gateway’ filed.
Note: Using an invalid Gateway Address can make the controller unable to
communicate. Again, we recommend you use the generated ‘IP Gateway’ address
from step 8.
11. Press ‘Save’.
Figure 16 - Remote Administrator – Connectivity Tab
12. After pressing ‘Save’, you may see the following dialog. Press yes and be sure to
change the address of your local network adapter IP Address to be in the same
network neighborhood of the controller. Your controller and network adapter are in
the same neighborhood when both their IP Addresses have the same first three
numbers and have the same Subnet Mask.
To Next Page
Loading...
Need help?
General