Page 4 - Manual FA01810-EN - 06/2022 - © CAME S.p.A. - The contents of this manual may be changed at any time and without notice. - Translation of the original instructions
• The electrical cables must pass through special pipes, ducts and cable glands
in order to guarantee adequate protection against mechanical damage. • The
electrical cables must not touch any parts that may overheat during use (such as
the motor and transformer). • Before installation, check that the guided part is in
good mechanical condition, and that it opens and closes correctly. • The product
cannot be used to automate any guided part that includes a pedestrian gate, unless
it can only be enabled when the pedestrian gate is secured. • Make sure that
nobody can become trapped between the guided and fi xed parts, when the guided
part is set in motion. • All fi xed controls must be clearly visible after installation, in a
position that allows the guided part to be directly visible, but far away from moving
parts. In the case of a hold-to-run control, this must be installed at a minimum
height of 1.5 m from the ground and must not be accessible to the public. • Where
operated with a hold-to-run control, install a STOP button to disconnect the main
power supply to the operator, to block movement of the guided part. • If not already
present, apply a permanent tag that describes how to use the manual release
mechanism close to it. • Make sure that the operator has been properly adjusted
and that the safety and protection devices and the manual release are working
properly. • Before handing over to the fi nal user, check that the system complies
with the harmonised standards and the essential requirements of the Machinery
Directive (2006/42/EC). • Any residual risks must be indicated clearly with proper
signage a xed in visible areas, and explained to end users. • Put the machine’s
ID plate in a visible place when the installation is complete. • If the power supply
cable is damaged, it must be immediately replaced by the manufacturer or by an
authorised technical assistance centre, or in any case, by qualifi ed sta , to prevent
any risk. • Keep this manual inside the technical folder along with the manuals of
all the other devices used for your automation system. • Make sure to hand over
to the end user all the operating manuals of the products that make up the fi nal
machinery.
The product, in its original packaging supplied by the manufacturer, must only be transported in a
closed environment (railway carriage, containers, closed vehicles).
If the product malfunctions, stop using it and contact customer services at https://www.came.com/
global/en/contact-us or via the telephone number on the website.
The manufacture date is provided in the production batch printed on the product label. If
necessary, contact us at https://www.came.com/global/en/contact-us.
The general conditions of sale are given in the o cial CAME price lists.
To Next Page
Loading...
Need help?
General
