- 05/2015 - © Came S.p.A. - The manual's contents may be edited at any time without notice.
Cycle lamp:
(contact rating: 230V - 60W max.).
It lights up the driving area and
stays on from the moment the
gate begins to open until it is fully
closed (including the automatic
closing time). If automatic closing
is not activated, the lamp stays on
only during movement.
Set DIP 1 and 6 switch to ON.
Movement fl ashing light
(Contact range: 230V - 25W
max) - Flashes during the gate’s
opening and closing phases.
Warning devices
Open-gate status light
(contact range:
24V - 3W max)
- Signal that gate is open;
turns o when gate is
closed.
Command and control devices
Stop button (N.C. contact)
- Gate stop button. Excludes automatic closing. For motion to resume, press the command
button or the remote control button.
N.B.: If unused, set DIP 9 switch to ON.
Key selector and/or command button (N.O. contact)
- Gate opening and closing command. By pressing the button or turning the
selector key, the gate inverts its movement or stops depending on which the
settings on the DIP switches .
Key selector and/or partial opening button (N.O. contact)
- Partial gate opening for pedestrian access.
Close-gate status light
(contact range:
24V - 3W max)
- Signal that gate is close;
turns o when gate is open.
To Next Page
Loading...
