CAME BX-74 - Control Board - Basics; General Description; Main Components

ïïïïïïïï
ï
ï
ï
ï ïï ï ï
AF
1234
ON
5678
910
1234
ON
12
2
10
3
5 7 6
11
9
4
8
1
p.
11
11 - Manual code:
FA00127-EN
FA00127-EN v.
1
- 05/2015 - © Came S.p.A. - The manual's contents may be edited at any time without notice.
6.1 General description
6 Control board
FUSE TABLE
To protect: fuse:
Control board (line) 5A-F
Accessories 1A-F
Command devices 630mA-F
TECHNICAL INFORMATION
Power supply 230V - 50/60 Hz
Maximum power allowed 200 W (BX74)
300 W (BX78)
Absorption at rest 65 mA
Max power of 24V accessories 20 W
6.2 Main components
1 - Power supply terminals
2 - Line fuse
3 - Accessory fuse
4 - Card fuse
5 - Button for memorising the radio code
6 - Trimmer PAR.OP.: Partial opening adjustment
7 - Trimmer ACT.: Automatic closing time adjustment
8 - Function selector (4) DIP switch
9 - Function selector (10) DIP switch
10 - Socket for connecting the remote control’s
11 - Radio-code signalling LED indicator
12 - Accessories’ and command device’s terminals
Orange
Blue
Violet
White
Red
Black
Use 230V AC to power the electronic card using the L-N
terminals, at a max 50/60Hz frequency.
Use 24V to power the command devices and accessories.
Careful! The accessories cannot exceed 20W of overall power.
The photocells may be set up for re- opening during closing
(2-C1), partial stop, total stop and obstacle detection when motor
is stopped.
Note: when a normally closed safety contact (i.e. 2-C1, 2-C3 or
1-2) is opened, the signalling LED starts to fl ash (ref. point 11,
main components).
The optical reader inverts the gate’s direction of travel when
it detects and obstacle during its opening and/or closing
movement.
Warning: after 3 obstacle detections, the gate stops when in
opening-mode and excludes automatic-closing mode; to regain
movement press the command button or use the remote control.
All connections are protected by quick-fuses – see table.
The card handles the following functions:
- Automatic closing after an opening command;
- Warning light pre-fl ashing;
- Obstacle detection when gate is still at any point;
The following command modes are possible:
- Opening/closing;
- Opening/closing in maintained action mode;
- partial opening;
- total stop.
Apposite trimmers regulate:
- The automatic closing’s running time;
- The partial opening;
Warning! Before acting on the machinery, cut o the main
power supply and disconnect any emergency batteries.