CAME G5000 - Control Devices and Connectivity; Device Connections; Accessory Card Installation

AF
R700
R800
10 11 E1 E6 Rx Tx 1 2 3 3P 4 5 7 CX CY
GND A B S1 GND
p. 18 - Manual FA00571-EN v. 1 - 08/2017- © CAME S.p.A. - The contents of this manual may be changed, at any time, and without notice.
CONTROL DEVICES
Antenna with RG58 cable
OPEN-CLOSE-INVERT function (step-step) from control
device (NO contact).
ONLY CLOSE function from control device (NO contact).
Warning: in MAINTAINED ACTION mode, the control
device must be connected to 2-4.
Warning! OPEN ONLY function from control device
with NO contact. Connect only to paired or alternate
installations. (see chapter called PAIRED FUNCTION or
ALTERNATE FUNCTION)
OPEN ONLY function from control device with NO
contact.
Warning: in MAINTAINED ACTION mode, the control
device must be connected to 2-3.
STOP button (NC contact). For stopping the boom while
excluding the automatic closing. To resume movement
either press the control button or any other control
device.
If unused, select 0 (Deactivated) from Function F1.
Keypad selector
Transponder or card reader
Fit the R700 decoding card for
recognition of the TSP00 sensor or the
LT001 card reader.
Fit the R800 decoding card so
that the keypad selector can be
recognized.
WARNING! Before fitting any plug-in card, such as the AF or R800 one, YOU MUST CUT OFF THE MAINS POWER SUPPLY and, if
present, disconnect any batteries.
Fit the AF radio-frequency card to control the barrier
via a transmitter.
Black
Red
Blue
White