How to fix air leak between housing and nose of Campbell Hausfeld IronForce IFN2190 Nail Gun?
If there's an air leak between the housing and nose of your Campbell Hausfeld Nail Gun, it's likely due to damaged O-rings, which should be replaced. Another possible cause is damage to the bumper, in which case, replace the bumper.
Why is my Campbell Hausfeld IronForce IFN2190 leaking air at the trigger valve?
If your Campbell Hausfeld Nail Gun is leaking air at the trigger valve area, the O-rings in the trigger valve housing are likely damaged. You should replace the O-rings and check the operation of the Work Contact Element (WCE).
General| Type | Framing Nailer |
|---|---|
| Operating Pressure | 70-120 PSI |
| Nail Angle | 21 degrees |
| Fastener Type | Framing Nails |
| Nail Size | 2 - 3 1/2 in |
| Magazine Capacity | 60 nails |
General safety rules for tool operation.
Maintaining a safe and organized work environment.
Critical personal safety practices and protective gear.
Guidelines on how to use the tool correctly and safely.
Instructions for maintaining the tool, parts, and accessories.
Procedure for lubricating the tool before and during use.
Diagram and instructions for connecting the air system.
Step-by-step guide to loading nails into the nailer.
Procedures for safely removing nails from the nailer.
How to adjust the depth at which nails are driven.
Contact information for technical help and manual requests.
Using genuine parts and fasteners for optimal performance.
Recommendations for qualified personnel and approved parts for repair.
Steps for cleaning and lubricating internal parts during repair.
Proper storage of the tool in a cool, dry place.
To Next Page
