5. Once level, tighten the V-bolt nuts by hand until hand-tight, then gently tighten with a
wrench and recheck the level (FIGURE 7-5 (p. 16)).
CAUTION:
Do not over-tighten V-bolt as it will cause the plastic to break.
FIGURE 7-5. ClimaVUE 50 with connector cable
6. Mate the extension cable connector to the cable connector shown in FIGURE 7-5 (p. 16).
Only hand tighten the connectors.
CAUTION:
Hand tighten only! Using tools to tighten the connectors can permanently weld the
stainless steel connectors together.
7. Route the cable down the pole to the instrument enclosure.
8. Secure the cable to the crossarm (if applicable) and tripod or pole by using cable ties.
ClimaVUE 50 Compact Digital Weather Sensor 16
To Next Page
Loading...