BLOW PRET – READ ONLY – Duraiton of the blower pre-purge cycle.
Default: 5 seconds
BLOW PRER – READ ONLY – Blower modulaiton rate during pre-purge.
Default: 50%
BLOW POST – READ ONLY – Duraiton of the blower post-purge cycle.
Default 30 seconds
BLOW POSR – READ ONLY – Blower modulaiton rate during post-purge.
Default: 50%
MIN MOD – Minimum blower modulation speed, as percent of full firing rate.
Set at factory.
START MOD – Blower modulaiton speed at light off. Set at factory.
MAX MOD – Maximum blower modulation speed, as percent of full firing
rate. Set at factory.
FLAME CURRENT – READ ONLY – Actual real-time flame sensor reading,
varies form 0.5 to 5.0.
IGN TYP – READ ONLY – Not used, MOD (or “modulating blower”) is the
only option.
To Next Page
Loading...
