ID CARD – READ ONLY – Not used, for factory use only.
SOFTWARE ID – READ ONLY – Not used, for factory use only.
ERROR CODE – READ ONLY – Current error code, if in lockout condition.
7.4.7 – Manual Override Menu
The MAN OVR MENU can be used to force the unit into operaiton. This level
is restricted to the installer and requires a code to access.
Default: AUTO, control decides operaiton based on programmed settings
Option: OFF, force disable
Option: HAND, force enable
TIME OUT – Set the maximum amount of time to operate in manual override
mode, before reverting to AUTO, in hours. Default: one (1) hour.
HTR MOD – Specify firing rate during manual override. Default: OFF.
To Next Page
Loading...
