EasyManua.ls Logo

Can-Am DS70 - Battery; Fuse

Can-Am DS70
132 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MAINTENANCE PROCEDURES
Battery
Battery Removal/Installation
WARNING
Never charge a battery while in-
stalled in vehicle.
These vehicles are equipped with a
VRLA battery (Valve Regulated Lead
Acid). It is a maintenance-free type
battery, there is no need to add water
to adjust electrolyte level.
CAUTION Never remove the
battery sealing cap.
Clean battery post with a wire brush.
Apply dielectric grease on post to pro-
tect against oxidation.
Removal
Disconnect BLACK (-) cable first then
RED (+) cable.
vmo2008-008-017_b
1. BLACK (-)
2. RED (+)
WARNING
Always respect this order for dis-
assembly; disconnect BLACK (-)
cable first. Fuel vapors can be
present in engine compartment
and a spark may ignite them and
possibly cause personal injuries.
Remove battery from vehicle.
Installation
Reinstall battery in vehicle.
WARNING
ConnectRED(+)cablefirstthen
BLACK (-) cable. Always connect
RED (+) cable first.
Fuse
Fuse Replacement
The electrical system is protected with
a fuse.
Ifthefuseisdamaged,replaceitby
one of the same rating.
CAUTION Do not use a higher
rated fuse as this can cause severe
damage.
Fuse holder is located on the RED (+)
battery cable.
_____________________
91

Table of Contents