MAINTENANCE PROCEDURES
Wheels Removal/Installation
Loosen bolts then lift vehicle. Place a
support under vehicle. Remove bolts
then remove wheel.
At installation, it is recommended
to apply anti-seize lubricant on bolts
threads. Gently tighten bolts in a
criss-cross sequence then apply a fi-
nal torque.
WHEEL NUTS TORQUE
Front 40 N•m (30 lbf•ft)
Rear 40 N•m (30 lbf•ft)
Wheel Bearing Condition
Push and pull the wheels from the up-
per edge to feel the play. See an autho-
rized Can-Am dealer if there is any play.
V07H03Y
TYPICAL
Steering System
Front Knuckles Lubrication
DS 70/DS 90
Lubricate front knuckles. Use syn-
thetic grease (P/N 293 550 033) or an
equivalent. There is a grease fitting on
each knuckle.
vmo2008-008-037_a
TYPICAL
1. Grease fitting
Brakes
Brakes Inspection (mechanical)
DS 70/DS 90
WARNING
Any brake system repair should
be performed by an authorized
Can-Am Dealer.
Check brake levers free-play, adjust if
necessary.
Check for levers operation, theyshould
move freely and have a firm feeling
when brakes are applied.
If correct adjustment is unattainable,
see an authorized Can-Am dealer.
_____________________
95
To Next Page
Loading...
