211
Handy Features
Text Entry Procedure
Changing the entry area:
Press the <Q> button to toggle
between the top and bottom entry
areas.
Moving the cursor:
Press the <U> key to move the
cursor.
Entering text:
In the bottom area, press the <S> key or turn the <6> dial to
select a character, then press <0> to enter it.
Changing the entry mode:*
Select [ ] at the bottom right of the bottom entry area. Each
time you press <0>, the entry mode will change as follows: Lower
case → Numerals / Symbols 1 → Numerals / Symbols 2 → Upper
case.
* When [Touch control: Disable] is set, you can display all the
available characters on one screen.
Deleting a character:
Press the <L> button to delete one character.
Exiting:
Press the <M> button, check the text, select [OK], then press
<0>. The screen in step 2 will reappear.
Canceling the text entry:
Press the <B> button, check the text, select [OK], then press
<0>. The screen in step 2 will reappear.
You can also set or check the copyright information with EOS Utility
(provided software, p.364).
To Next Page
