50
The camera can reconnect to another camera for which connection
settings have been registered.
1
Select [Wi-Fi function].
Under the [51] tab, set [Wi-Fi/NFC]
to [Enable], then select [Wi-Fi
function].
2
Select [z].
Select [z] (Transfer imgs between
cameras) and press <0>.
3
Establish a connection.
Select [Connect] and press <0>.
On the confirmation dialog, select
[OK]
.
Perform the reconnection procedure
on the target camera as well.
X
The images on the card are displayed
and the images to send can be selected.
When settings for multiple connection destinations are registered,
select [Choose set.], select the connection destination, then
connect to the destination.
By default, settings are named after the nickname of the camera that
was connected to.
Reconnecting
If Wi-Fi settings are cleared (p.137) or the connection setting is deleted
(p.136) on the target camera, reconnection will no longer be established.
Select [Review/change settings] and change the settings (p.134).
To Next Page
