Adjusting the feed amount
Banding Adjustment During Printing (Fine Band Adj.)
If, during printing, the contrast is uneven sideways across the paper or banding in dif ferent colors appears every
40 mm (1.6 in) or so, try adjusting the feed amount as follows. The results of adjustment are applied to printing
in progress, enabling you to check the results immediately . However , note that because printing is paused,
colors may be slightly dif ferent.
Use Fine Band Adj. after Auto Band Adj. or Manual Band Adj if ner adjustment is required. ( → P .578) ( → P .580)
Note
• The Fine Band Adj. value is reset to 0 if you use Auto Band Adj. or Manual Band Adj .
Execute Fine Band Adj. during printing as follows.
1. Press the Online button to pause printing.
2. Press the Menu button to display the menu during printing. ( → P .66)
3. Press ▲ or ▼ to select Menu Durng Prtng , and then press the OK button.
4. Press ▲ or ▼ to select Fine Band Adj. , and then press the ► button.
5. Press ▲ or ▼ to change the value, and then press the OK button.
Note
• The supported range is -5 to +5.
6. Press the Online button to resume printing.
582 Adjustments for Better Print Quality
Downloaded from ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General