Printing at full size
Borderless Printing at Actual Size (W indows)
This topic describes how to print borderlessly at actual size based on the following example.
If you use an A1 or A2 roll for borderless printing, insert the provided Spacer for Borderless Printing on the
Roll Holder . ( → P .143)
If you do not attach the Spacer for Borderless Printing , the Platen may be soiled from borderless printing.
• Document: Any type
• Page size: 10×12 inches (254.0×304.8 mm)
• Paper: Roll
• Paper type: Heavyweight Coated Paper
• Roll paper width: 10 inches (254.0 mm)
1. Create the original in the source application 3 mm (0.12 in) larger on each side than 254.0×304.8
mm (10 × 12 in) -that is, 260.0×310.8 mm (10.2 × 12.2 in)
Note
• If you can specify the margin, as in Microsoft W ord, set the margin at 0 mm. For instructions on
specifying the margin, refer to the software documentation.
• The extra 3 mm (0.12 in) on each side will not be printed. Create the original so that it ts inside the
paper area to be printed on.
2. Choose Print in the application menu.
3. Select the printer in the dialog box, and then display the printer driver dialog box. ( → P .404)
4. Make sure the Main sheet is displayed.
5. In the A Media T ype list, select the type of paper that is loaded. In this case, click Heavyweight
Coated Paper .
6. Select the print target in the E Print T arget list.
Enhanced Printing Options 265
To Next Page
Loading...
Need help?
General