Messages regarding paper
Paper size not detected.
Cause Corrective Action
Paper has been loaded askew , or warped paper has
been loaded.
Reload paper straight, in the correct position.
( → P .122)
( → P .151)
*If this message is displayed, you can resume the print job.
Insufcient paper for job
Cause Corrective Action
Follow the steps below to replace the roll.
1. Remove the roll.
( → P .124)
( → P .125)
( → P .126)
2. Load a roll with enough paper left.
( → P .1 19)
( → P .121)
( → P .122)
3. If no barcode was printed on the roll, specify the
paper type.
( → P .1 17)
4. Select the paper length, unless a barcode was
printed on the roll and you have deactivated
automatic detection of the remaining roll paper .
( → P .1 18)
Hold down the Stop button for a second or more to
cancel printing.
The printer has received a print job longer than the
amount of roll paper left.
Press the Online button to resume printing.
However , the roll paper may run out during the
print job and you may not be able to print all of the
document.
690 Error Message
To Next Page
Loading...
