Messages regarding paper
Cannot cut paper .
Cause Corrective Action
There are sheets left on the Ejection Guide . Remove the paper .
There is a foreign object by the Output T ray ,
obstructing the Cutter Unit .
Remove the foreign object.
Y ou are not using the printer under the recommended
environmental conditions for the paper .
Use the printer only where the recommended
environmental conditions for the paper are met.
Note that various environmental conditions are
recommended for various types of paper . For details
on the recommended environmental conditions for
paper , see Paper Reference Guide ".
( → P .108)
Y ou are using paper that is not compatible with
automatic cutting.
Specify Manual as the method for cutting rolls and
cut the roll manually .
( → P .135)
For details on automatic cutting compatibility , see the
Paper Reference Guide .
( → P .108)
The Cutter Unit stops in the middle of cutting. Move the Cutter Unit to the left, and then remove the
roll paper . If cutting is not possible using the Cutter
Unit , specify Manual as the method for cutting rolls
and cut the roll manually .
( → P .127)
( → P .135)
In other cases, the Cutter Unit may be damaged. Contact your Canon dealer for assistance.
*If this message is displayed, you can resume the print job.
End of paper feed.
Cause Corrective Action
Y ou are pressing the ▲ button on the Control Panel
and trying to rewind the roll to the edge.
Release the ▲ button.
Error Message 695
To Next Page
Loading...
