Recalling a Previous Copy Setting (Recall)
2-57
Useful Copy Functions
2
Recalling a Previous Copy Setting (Recall)
With this function, you can recall up to three previous copy settings and make copies using
these settings.
IMPORTANT
• One copy job is defined by setting the number of copies, exposure, copy ratio, etc., and pressing
(Start) or (Reset) when the Auto Clear function is “On”, or by calling up a copy job stored
in memory. If one of these keys was not pressed, or if the Auto Clear function is not active, then
calling up a copy job by pressing “Recall” is not possible.
• The Standard mode cannot be recalled by this procedure.
• Identical copy settings are counted as one setting.
NOTE
•
Once stored, the last three copy settings are held in memory even if the power is turned off.
1
Place your originals, and press “Special Features” “Recall.”
2
Select either “1 Before,” “2 Before,” or “3 Before” confirm the
settings press “OK” “Done.”
The display returns to the Basic Features screen.
NOTE
• You can also check which copy jobs are stored to memory other than the currently
displayed copy job by pressing “▲” or “ ▼.”
3
Press (Start).
Copying starts.
To Next Page
Loading...
Need help?
General
