Making Copies with Sheets of Paper Interleaved Between Transparencies (Trans-
parency Interleaving)
2-15
Useful Copy Functions
2
Making Copies with Sheets of Paper Interleaved
Between Transparencies (Transparency Interleaving)
Use this mode when copying onto transparencies fed from the stack bypass. The machine
automatically interleaves a sheet of paper between each transparency. The interleaf sheets
protect the copied surface of the transparencies. The image can also be printed on the
interleaf sheets.
IMPORTANT
• When the machine is operating in the Transparency Interleaving mode, you cannot use the
Finisher, Two-sided, Two-page Separation, Cover/Sheet Insertion, Booklet, Image Combination,
Image Separation, Image Repeat, or Mirror Image modes.
• You cannot make more than one set of copies at a time in the Transparency Interleaving mode.
• Even if your machine is equipped with the Finisher, you cannot use any of the Finisher modes
with the Transparency Interleaving mode.
NOTE
•
The machine’s counter does not count blank interleaf sheets as copies.
•
Transparencies are output into Tray A when Inner 2way Tray-A1 is attached, and into Tray B in the
case of Saddle Finisher-G1, even if the other tray is specified as a designated tray.
■ When Not Printing on the Interleaf Sheets:
Outputs a printed transparency and a blank interleaf sheet alternately.
REPORT REPORT
Originals
Copies
Transparencies
Blank interleaf
sheets
To Next Page
Loading...
Need help?
General
