Staple Finisher-Y1/Booklet Finisher-Y1/Buffer Pass Unit-
L1/2/4 Hole Puncher Unit-A1/2/3 Hole Puncher Unit-
A1/4 Hole Puncher Unit-A1
13WK-0HR
Install "Staple Finisher-Y1" or "Booklet Finisher-Y1" to use the following nish functions.
Collate
The printouts are collated into sets arranged in page order of the original.
Group
All printouts of the same original page are grouped together into sets.
Offset
Each printout group is shifted in alternating layers.
Staple + Collate
The printouts are collated into sets arranged in page order and stapled (Corner/Double). You can saddle stitch and
output the printouts by using the "Booklet Finisher-Y1."
Staple + Group
All printouts of the same original page are grouped together into sets and stapled (Corner/Double).
Staple Free
The printouts are crimped and bound without using a staple. You can easily split the paper by pressing the crimped
part with your ngers. This function is useful for saving staples and also binding printouts briey.
● For information on the paper sizes that can be used for Staple Free, see Specications(P. 1029) .
● Depending on the usage environment and paper type, the crimped part may be split easily.
Manual Stapling
You can manually staple printed paper by inserting paper in the slit. As an example of use, you can remove staples
bound to the original, copy or scan it, and then staple the original again.
Saddle Fold (Booklet Finisher-Y1 only)
The printouts are folded into half its size. Up to three sheets together can be folded.
TIPS
● If you install the "2/4 Hole Puncher Unit-A1", "2/3 Hole Puncher Unit-A1", or "4 Hole Puncher Unit-A1" in the
"Staple Finisher-Y1" or "Booklet Finisher-Y1," you can punch holes in your printouts.
Appendix
1106
To Next Page
Loading...
Need help?
General
