Operating Procedure
36
2
Various Ways to Copy
If transparencies do not feed
smoothly
Sometimes transparencies may not feed
easily into the copier after the key is
pressed. When this happens, follow the
procedure below.
Place a sheet of standard copy paper
underneath the transparency. Position
this paper so that it extends
approximately 3/8” beyond the leading
edge of the transparency.
3/8"3/8"
Hold the rear end of the two sheets as
shown and insert them into the multi-
stack tray.
While holding the rear edge of the sheets
press the key.
When the transparency begins to feed
into the copier, let go of the sheets. After
the transparency paper has disappeared
into the copier, remove the copy paper by
pulling it gently out from the paper feed
slot.
Making Two-sided
Copies
This copier can copy on both
sides of copy stock.
Position the first original onto the platen
glass.
ABC
Make a copy of the first original.
(See “Normal Copying” on p. 30.)
02/ PC140-USA 10/10/03, 7:38 AM36
To Next Page
Loading...
Need help?
General
