Settings front side What to enter
[Z offset ({0})] The image is shifted in Z direction (perpendic-
ular on the feed direction) in mm (inches).
A shift > 0 moves the image to the top of the
sheet:
• The distance between the top of the sheet
and the image on the sheet decreases.
• The circles on the verification chart move to
the top of the sheet.
A shift < 0 moves the image to the bottom of
the sheet:
• The distance between the top of the sheet
and the image on the sheet increases.
• The circles on the verification chart move to
the bottom of the sheet.
Settings back side What to enter
[X offset ({0})] The image is shifted in X direction (feed direc-
tion) in mm (inches).
A shift > 0 moves the image to the right-hand
side (trailing edge):
• The distance between the leading edge of
the sheet and the image on the sheet increa-
ses.
• The distance between the trailing edge of
the sheet and the image on the sheet de-
creases.
• The dots on the verification chart move to
the right-hand side (trailing edge).
A shift < 0 moves the image to the left-hand
side (leading edge):
• The distance between the leading edge of
the sheet and the image on the sheet de-
creases.
• The distance between the trailing edge of
the sheet and the image on the sheet increa-
ses.
• The dots on the verification chart move to
the left-hand side (leading edge).
4
Values for the Media Registration
334
Chapter 13 - Media Handling
Canon varioPRINT DP line
To Next Page
Loading...
