2-7
Setting Up
Once your PC and the camera are connected, perform the initial settings next. The instructions
here follow on from “2. Connect the Camera to the Network”, where one camera is connected to
a PC as an example.
3. Perform Initial Settings for the Camera
Note
Do not turn on the camera at this stage.
○○○○○○○○○
Continued on the following page. a
Supplied CD-ROM
LAN cable
VB-C50i
Hub
Installation Example
1. Turn on the network device (in this case, the hub) and then your PC.
2. Insert the CD-ROM provided into your PC and from Explorer etc. double-click
“VBSetup.exe” to start the VB Initial Setup Tool. Turn on the VB-C50i.
002-VBC50i-E-US 06.7.6, 11:33 AM7
To Next Page
Loading...
