201
Installation and Maintenance Maintenance
Replacing the Lamp
When the usage time of the lamp exceeds a certain amount of time, the following
message (two types) is displayed for 10 seconds every time the projector is turned
on.
2,700 hours to less than 3,000 hours
Prepare a new lamp when this screen is displayed.
• Only the [ ], [ ], OK and POWER buttons are available while this screen is
displayed.
• When you press the POWER button, the “Push POWER button again to turn off
power.” message appears.
• When this screen has disappeared after being displayed for 10 seconds, all
buttons become operable.
• This message will not be displayed again if you select [No] in response to the
message “Do you want to display this message again?”.
3,000 hours or more
If this screen is displayed, replace the lamp by referring to the procedure on page
202.
• Only the POWER button is available while this screen is displayed.
• When you press the POWER button, the “Push POWER button again to turn off
power.” message appears.
• When this screen has disappeared after being displayed for 10 seconds, all
buttons become operable.
• You can check the usage time of the lamp in [Lamp counter] in the [System
settings] menu. (P119)
• This screen is not displayed when [Lamp warning display] is set to [Off]. (P156)
To Next Page
Loading...
Need help?
General
