Caple DD912BK - Grease Filter Removal, Installing the Activated Charcoal Filter

Instruction manual DD912BK
13
Please keep this instruction manual for future reference
GREASE FILTER REMOVAL,
INSTALLING THE CHARCOAL FILTERS
The removal and fitting of the grease and charcoal filters need to be carried out with the
downdraft in the open position. To open the downdraft, push the
move
up
How to use the extractor
some
ducted
recirculating
ducted
extracted
/ducting
is
Check for a non
Recirculating
recirculating
(code: CAP43CF)
11).
Removing the grease filter and
installing the charcoal filter
coal

move
up
How to use the extractor
some
ducted
recirculating
ducted
extracted
/ducting
is
Check for a non
Recirculating
recirculating
(code: CAP43CF)
11).
Removing the grease filter and
installing the charcoal filter
coal
the
 key
move
up
How to use the extractor
some
ducted
recirculating
ducted
extracted
/ducting
is
Check for a non
Recirculating
recirculating
(code: CAP43CF)
11).
Removing the grease filter and
installing the charcoal filter
coal

9. Connnect the internal or external
motors cable to the terminal board found
inside the plastic box of the downdraft
wiring. Ensure you respect the power
cables wiring colours when perfoming the
electrical connection
key. Then remove the front
panel, pushing the upper part of each side at the same time. The panel will rotate forwards to
make it possible to access the grease filters (Fig. 6) Remove the grease filters to access the
carbon filters.
(Fig. 12). The replacement of the charcoal filters has to be carried out accordingly to the effective
use of the downdraft, and in any case at least one every six months.
WARNING:
After having replaced the filters, reinstall the front stainless steel panel, otherwise the downdraft is
not functional.
6
12
NOTE:
Replacement filters (CAP43CF) can be purchased at www.caple.co.uk.