44
Factory Service Department | Phone: 1-866-784-6900 | Fax: 1-919-516-8710
Start-Up and Maintenance Documentation
START-UP AND MEASUREMENTS SHOULD BE PERFORMED AFTER THE SYSTEM HAS BEEN AIR
BALANCED AND WITH THE HEAT ON (Warranty will be void without completion of this form)
Job Information
Heater Information
Refer to the start-up procedure in this manual to complete this section.
Maintenance Record
Job Name Service Company
Address Address
City City
State State
Zip Zip
Phone Number Phone Number
Fax Number Fax Number
Contact Contact
Purchase Date Start-up Date
Name Plate and Unit Information Field Measure Information
Model Number Motor Voltage
Serial Number Motor Amperage**
Hardware Rev. RPM
Software Rev. Burner Differential Pressure Inches WC
Motor Volts Pilot Flame Signal VDC
Motor Hertz Low Fire Flame Signal VDC
Motor Phase High Fire Flame Signal VDC
Motor FLA High Fire Inlet Gas Pressure Inches WC
Motor HP Low Fire Manifold Gas Pressure Inches WC
Blower Pulley High Fire Manifold Gas Pressure Inches WC
Motor Pulley Thermostat Set Point
Belt Number Gas Type
Min. Btu/Hr
Max. Btu/Hr
Gas Type
Temperature Control Discharge
**If measured amps exceed the FLA rating on the nameplate,
fan RPM must be reduced to decrease the measured amps
below the nameplate FLA rating.
Space
Airflow Direction Correct
Incorrect
Date Service Performed
To Previous Page
Loading...