CTR12000 Car-O-Liner Group AB
41644, EN - rev. 2, 2012-09 45
3.9 Welding program management
The following function can be selected and called from the MEMORY
screen.
DELETE welding programs
Attention: The use of this function is only possible in EDIT- mode! It is
necessary that an USB- key is in the USB- device!
After you have pressed the soft key F2 under the MEMORY field and have
selected the menu PRINT, the following screen is displayed:
The window that pops up and program stack “ACTION” gives access to the
function, DELETE.
To Next Page
