29
SETUP AND CALIBRATION, Cont.
The general format for the input is A = YY.XX where A is the
character identifying the data printed, YY is the number of lines down
and XX is the number of spaces to the right.
NOTE!
Enter 00 in either location, YY or XX, to disable the
data from printing.
Port= (Select Port for Printer)
Press the
ENTER
key to show the current value. If the setting displayed is acceptable, press the
ENTER
key again to save it. Otherwise, using the numeric keys enter the new setting, then press
the
ENTER
key to save it. Allowable values are: 1 or 2.
NOTE!
Although either port can be used for the printer port, it is recommended to use
the bi-directional port 1 with a bidirectional cable.
HoUr= (Time Print Location)
Press the
ENTER
key to show the current setting for the location of the time printing. If the setting
displayed is acceptable, press the
ENTER
key again to save it. Otherwise, use the numeric keys
to enter the new location then press
ENTER
to save it.
dAtE= (Date Print Location)
Press the
ENTER
key to show the current setting for the location of the date printing. If the setting
displayed is acceptable, press the
ENTER
key again to save it. Otherwise, use the numeric keys
to enter the new location then press
ENTER
to save it.
CnC n= (Consecutive Number Print Location)
Press the
ENTER
key to show the current setting for the location of the consectutive number
printing. If the setting displayed is acceptable, press the
ENTER
key again to save it. Otherwise,
use the numeric keys to enter the new location then press
ENTER
to save it.
GroSS= (Gross Weight Print Location)
Press the
ENTER
key to show the current setting for the location of the Gross weight printing. If
the setting displayed is acceptable, press the
ENTER
key again to save it. Otherwise, use the
numeric keys to enter the new location then press
ENTER
to save it.
tArE= (Tare Weight Print Location)
Press the
ENTER
key to show the current setting for the location of the Tare weight printing. If the
setting displayed is acceptable, press the
ENTER
key again to save it. Otherwise, use the numeric
keys to enter the new location then press
ENTER
to save it.
nEt= (Net Weight Print Location)
Press the
ENTER
key to show the current setting for the location of the Net weight printing. If the
setting displayed is acceptable, press the
ENTER
key again to save it. Otherwise, use the numeric
keys to enter the new location then press
ENTER
to save it.
G ACC= (Gross Weight Accumulator Print Location)
Press the
ENTER
key to show the current setting for the location of the Gross weight accumulator
printing. If the setting displayed is acceptable, press the
ENTER
key again to save it. Otherwise,
use the numeric keys to enter the new location then press
ENTER
to save it.
To Next Page
Loading...
Need help?
General
